ibexa

Caution: This documentation is for eZ Publish legacy, from version 3.x to 5.x.

module_params

Summary

Extracts parameters from the module that was run.

Usage

module_params()

Returns

An array containing module information.

Description

This operator extracts some generic information from the module that was run. It seems that it can only be called inside "pagelayout.tpl". Please refer to the example below. The operator does not take any parameters.

Examples

Example 1

{module_params()|attribute(show)}

If the requested URL is "/content/view/full/65" (or using URL alias that points to "/content/view/full/65"), the following output will be produced:

Attribute

Type

Value

module_name

string

'content'

function_name

string

'view'

parameters

array

Array(2)

-ViewMode

string

'full'

-NodeID

string

65

Please note that this operator can only be called in "pagelayout.tpl".

Balazs Halasy (05/02/2004 10:34 am)

Balazs Halasy (05/07/2005 11:16 am)


Comments

  • Writing out a single value

    I`d like to write out the NodeID by itself, but can`t seem to find a way to do this. While the following outputs the function_name value:

    {module_params.function_name}

    This for some reason fails to do the same for the NodeID:

    {module_params.>NodeID}

    Is there some other way I should do this, or might this feature be disabled for some good reason? Any help is appreciated.
    • Re: Writing out a single value

      Found the answer to this slightly silly question: Apparently >NodeID and >ViewMode are elements in the array 'parameters', so the two values are accessible by using eg:

      {module_params()[parameters][NodeID]}

      Hope this saves somebody else a little pointless frustration.